BMW e36 DIY kit

NOTE : this product does not include, housings. it is a diy product only

these drop-in boards are designed to fit the BMW e36 aftermarket housings, by using the clear lens model you unlock a full panel of RGB addressable lighting controlled from your phone.

the LEDs are 5v addressable straw hats, capable of producing a variety of show modes and functions from your phone. there are 4 basic pins, ground, positive, input, and output, head over to the DIY section of our page to read more about the specifications and wiring requirements.

the boards come flat and with an extra 15 LEDs / side to account for errors.
once you have your taillights open, place some painter's tape on the inside of the lens, heat the boards up to 100 degrees in the oven ( with the backing paper still on ), and then lay flat in your lense, voila, the board is ready to drop in.

there are two prices, one including the blughozt 2.0 module and one without. the light will need an RGB controller to operate only select without if you are using an alternative contorller. 

NOTE: we can accept custom design layouts - the fee is to be decided up on designs but feel free to message us via Instagram to begin discussing!!